4
System Setup
SuperDVR & TD Series Cards
User Manual
36
1. Video
Loss
Users can select alarm output for this option. For example, users select
alarm_out1 and alarm_out3 for video loss. Then video loss of any channel will
trigger alarm_out1, alarm_out3 to show red light in the Alarm output status
panel (refer to Figure3-6 for reference).
2. Disk
Alarm
When HDD available space is less than the set value (see Figure4-9), it will
trigger alarm.
3. Sensor
Sensor 1: If users have mounted sensors, when the sensors have been
activated, then it will trigger the selected output alarms.
Sensor 2 - Sensor 16: TwoTD4116 cards have maximum 16 sensors.
4. Motion
Motion 1: Users can set the output of motion detection alarm by different
alarms and remote alarm.
Motion 2 - Motion 16: 32CH card has maximum 16 motion alarms.
NOTICE
You should choose our additional alarm device board while using twoTD4116 cards for
alarm I/O.
4.5.4 Auto Mail Function
Now users can select the above-mentioned alarms to be output by Auto Mail.
Click ‘
Auto Mail
’ icon on the left top side of alarm configuration page and
enter the following area to make Auto Mail setup, referred Figure4-12.
Figure4-12 Auto Mail Setup Interface
In this area, users can set receiver and sender’s E-mail SMTP server and
address. Note: the address of receiver and sender can be the same.
