STEALTH1
6
After start up, the system will automatically enter live monitoring mode, with the following status indicators:
1. Date and Time
: Currently set date and time
2. Record Status:
Manual record settings
Record Resolution
Please refer to RECORD SETUP forVIDEO
SIZE setup instructions.
Record Quality
Please refer to RECORD SETUP or VIDEO
QUALITY setup.
3. SD Card Status:
No SD card installed or the card is malfunctioning
Reading SD card
SD card is functioning normally
MONITORING MODE
1. To turn the device on, first connect the power cable or insert batteries into the battery compartment.
2. Slide the power switch on the top of the device to the ON position.
3. To view the menus and adjust settings you will have to attach the included RC A cable to the video output of the
covert camera, and connect it to the video input jack on the back of your television.
4. After power on, the system will automatically enter live monitoring. If the system was previously set to
schedule or motion activated record, it will automatically resume to that recording mode.
5. After a power outage, the system will reboot and return to the previous record mode.
1. The
SD card icon shown on the status line, indicates that the SD card is operating normally.
2. If there is a problem or error with the SD card, the Play, Menu, and Rec LEDs will flash quickly.
If this happens, please re-format the SD card before proceeding (all saved video will be lost).
• To quickly format the SD card, turn the DVR off. Then hold the back and forward buttons and switch
the DVR on. A “Format OK” message will be displayed when the SD card is successfully formatted
3. When the SD card is recording video successfully, the record LED will flash slowly.
SD CARD INFORMATION
1
2
3
POWERING ON
NOTE: Each time the unit is powered on, the system will auto-detect the SD card. When the RECORD LED is
flashing, it is indicating that the SD card is currently being read. If a video file error has been detected,
the system will initiate repair to the card