www.defender-global.com
12
During the camera initialization the indicator for cloud mode and status indicator will flash with orange quickly. When
the camera will establish connection with the cloud service and will start streaming video, the cloud mode and status
indicator lights will start to flash with green light slowly. Next time (if the access point has been connected, the account
has been created and the camera has at least once already been successfully connected to streaming through cloud
service) when you need to switch the camera to cloud
again
, you can simply use the
“MODE”
button.
If the camera was unable to connect with the access point or with the cloud service, the cloud mode and status
indicator lights will start flashing with red color slowly and the camera will produce a sound signal. In a few seconds
the camera will switch to
“Access point”
mode. Connecting to the camera via
“Unieye”
application at this point will
allow you to see the message that will indicate what caused the error. The message might not indicate the cause
correctly. For instance, if the camera is blocked from incoming connections through 80 and 443 ports, the message will
show that the account login and password at the USTREAM server are incorrect. However, the nature of the message
does not change: the camera cannot connect to the cloud service. For possible types of errors and solutions see
TROUBLESHOOTING
section.
11.3 Viewing video stream from camera through cloud service, using Android mobile device with “Ustream”
application
There may be some differences between the instructions below and the actual location of menu items, depending
on the type of device and depending on the version if the installed operating system, however, the nature of these
settings will not change.
11.3.1 Authentification
1. Launch the
“USTREAM”
application for Android.
2. Press the
or
button and select
“Settings”
in the
appeared menu.
3. In the appeared window go to
“Account”
tab.
4. Click on
“Login or Sign up”
field in the appeared tab.
5. Enter account username and password that are used by
the camera to access
“USTREAM”
service in the appeared
window (the exact username and password that were used
to set up the camera) and press
“Login”
button.
