Page 16
Note -1:
There is no need to use a water filter in case
a jug is used.
Note -2:
A pump must be used when using the jug.
Connection of the Water Pipe to the Cold
Water Mains Line
(in some models)
If you want to use your refrigerator by
connecting it to the cold water mains line,
you will have to connect a standard 1/2”
valve connection fitting to the cold water
supply in your house. (In case this valve is
not present or if you are unsure, please
consult a qualified plumber).
1. Separate the union from the tap adaptor.
(Figure A).
2. Install the tap adaptor to a 1/2” valve fitting
as shown in the figure. (Figure B).
3. After inserting the water pipe to the union,
install it to the tap adaptor and insert to
the tap as shown in the figure. (Figure C).
4. Tighten the union manually. In case of a
leak use a correctly sized spanner to
tighten the union.
Warning:
Secure the water pipe to suitable points by
means of the pipe clips supplied to avoid any
damage or displacement or accidental
disconnection.
Warning:
After turning on the water valve, make sure
that there is no leakage at both connection
points of the water pipe. In case of a leak,
turn off the valve immediately and tighten all
joints again using a correctly sized spanner.
Warning:
Make sure that standard 1/2" valve fitting fed
by the cold mains water supply is available
and is turned off fully.
Summary of Contents for DFF402
Page 28: ...Page 28...
