Page 4
UNPACKING
•
Remove all packaging and dispose of it in a responsible manner.
•
Open the wash-tub lid and remove all the accessories stored in the drum.
•
Do not attempt to operate the machine while any of the packaging is still in place.
POSITIONING
•
The machine should be installed in a well ventilated
place, away from direct sunlight.
•
Hot and cold water taps should be located within 1 metre
of the inlet valves.
•
Positioned the machine on a flat and stable uncarpeted
floor capable of supporting the fully loaded washer.
•
An adjustable levelling foot is located at the right front
of the machine and may be turned in or out to achieve
stability. An unstable machine will vibrate and generate
excessive noise.
DRAIN HOSE
•
Connect the drain hose to the drain outlet at the rear of
the machine and secure it with the hose clamp supplied.
•
Hook the outlet end of the drain hose over the lip of a
sink or outlet pipe.
SINK OR LAUNDRY TUB DRAIN
•
The top lip of the sink must be at least 860mm (A) above
floor level and not higher than 1300mm.
PIPE DRAIN
•
The minimum inside diameter of the pipe drain should be
30mm and the pipe should be able to drain 30 litres per
minute.
•
The top lip of the pipe should be at least 860mm (B)
above floor level and not higher than 1300mm.
Installation
Drain hose
Hose clamp
Drain
outlet
A
B
