25
www.degometal.com
IMPORTANT
Check the tool against daily and weekly servicing
Priming is ALWAYS necessary after the too has been dismantled and prior to operating
PRIMING PROCEDURE
•
Remove bleed screw
9
and seal
10.
•
Connect air supply to tool and switch ON/OFF valve
55
to "ON" position
.
•
Invert tool over suitable container and actuate trigger
.
Waste oil will be ejected through the bleed
screw hole.
CARE SHALL BE TAKEN TO ENSURE THAT THE BLEED HOLE IS NOT DIRECTED
TOWARDS THE OPERATOR OR OTHER PERSONNEL.
•
Screw stop nut onto jaw spreader housing
1.
•
Disconnect air supply to tool or switch ON/OFF valve
55
to 'OFF" position
.
•
Fill the priming pump with oil.
•
Screw priming pump into the bleed screw hole with seal
10
in place.
•
Actuate the priming pump by pressing down and releasing several times until resistance is felt.
•
Remove the priming pump and the stop nut.
•
Replace bleed screw
9
and seal
10.
•
Connect air supply to tool and switch ON/OFF valve
55
to 'ON" position.
•
Check that the stroke of the tool meets the minimum specification of 26 millimetres
.
To
check the stroke, measure the distance between the front face of jaw spreader housing
1
and the front face of the head, BEFORE pressing the trigger and when the trigger is
fully actuated
.
The stroke is the difference between the two measurements
.
If it does
not meet the minimum specification, repeat the priming procedure.
Item numbers in
bold
refer to the general assembly drawing and parts list
.
IMPORTANT
DISCONNECT THE TOOL FROM THE AIR SUPPLY OR SWITCH OFF AT VALVE 55.
REMOVE NOSE ASSEMBLY OR SWIVEL HEAD COMPONENTS.
All operations should be carried out on a clean bench, with clean hands in a clean area.
Ensure that the new oil is perfectly clean and free from air bubbles.
Care MUST be taken at all times, to ensure that no foreign matter enters the tool, or serious damage may result.
Summary of Contents for GO 182
Page 13: ...13 www degometal com 6 VUE ÉCLATÉE ...
Page 27: ...27 www degometal com 6 EXPLODED DRAWING ...
Page 31: ...31 www degometal com ...
