36
www.degometal.com
Damage because the traction power is too high or
the working stroke is too long
Traction power (see point 4.2) or the working stoke
(see point 4.3)
Special warning: battery must be removed before
adjusting, otherwise it will cause personal injury.
Use a hex driver to unscrew (refer to point5.2 and
5.3.2; refer to illustrations 1,2,3,4)
Indicator 9 (GO3312 fig.A) blinks and stays on
Have the tool checked and serviced by qualified
personnel
1 – Rotate anticlockwise carefully to loosen rear cover 8.
2 – Expose the hexagonal hole at the rear end of the tool.
3 – Insert the hex screwdriver SW5 enclosed into the hexagonal
hole, rotate anticlockwise carefully to loosen, unscrew and
replace the rivet nut.
4 – If necessary, use the enclosed double head nut wrench SW
16/21 to rotate the hex screw driver, so as to unscrew
the rivet nut in an easier way.
9.3
Installed rivet nut is loose
Cause
Troubleshooting
Traction power is too low
Set traction power properly (refer to key point 4.2)
Released before reaching the set stroke
Set working stroke properly (refer to key point 4.3)
Summary of Contents for GO 3312
