Function
LED signal Meaning
To do
Boot up sequence
Approximately 5 sec. until
- - -
the SPDs are tested
Fault
Impermissible configuration
Check DIP switch at
the DRC SCM XT
(see 5.)
Protective devices
OK
- - -
Protective devices
SPD No. of the first SPD
Replace at least one
For example SPD No. 3
to be replaced
of the monitored
SPDs (see 8.)
Programming mode
active
See 7.
SPD testing
Reset mode
See detailed operating
manual of
DEHNrecord
DRC SCM XT
Contents:
1. Scope of delivery 3
2. General notes 3
3. Installation
3
4. Wiring
4
5.
Configuration
4
6. Operating procedure 5
7. Programming the SPD address (SCM address and position No.) 6
8. Determination of SPDs to be replaced 8
9. Manual abort during an ongoing SPD test 8
10. Technical data 9
11. Support
10
12. Safety instructions 10
13. Disposal
10
Page 2
DEHNrecord DRC SCM XT status display
Quick Guide DEHNrecord
DRC SCM XT