17
©
1999 Directed Electronics, Inc.
QUICK REFERENCE GUIDE:
To arm the system
■
You can arm the system by locking the doors with your factory keyless
entry transmitter. When the system arms, your will hear a short chirp,
and see the parking lights flash once.
To disarm the system
■
To disarm the system, unlock the doors using your factory keyless trans-
mitter. You will hear two chirps, and the parking lights will flash twice.
Disarming without a transmitter
■
Turn on the ignition. Press the Valet switch the programmed number of
times within 10 seconds. The system should now disarm. If it does not,
you may have waited too long. Turn the ignition off and on and try
again.
To enter or exit Valet
®
Mode
■
Turn ignition to “run” position, then turn to “off” position. Press and
release the Valet switch within 10 seconds. The status LED will light
solid if you are entering Valet Mode, and it will go out if you are exit-
ing Valet Mode.
To activate Panic Mode
■
Press the lock button on your factory keyless transmitter twice within
three seconds to enter Panic Mode. The siren will sound and the parking
lights will flash for 30 seconds. To stop Panic Mode at any time, press
the unlock button on your factory keyless transmitter.
NOTE:
If the unit is programmed to use the auxiliary output, Panic Mode
will not be operational.
Remote Valet
■
Open any door. Press the lock button on your transmitter. Within one
second, press the unlock button on your transmitter. Within one second,
press the lock button on your transmitter again. The status LED will stay
on if you have entered Valet Mode, and it will go out when exiting Valet
Mode.
Cut along dotted line and f
old f
o
r a quick and eas
y r
efer
ence to k
eep in y
our pur
se or w
allet.
✂✂
✂ ✂
