QUICK REFERENCE GUIDE:
To remote start the vehicle
1. Press the auxiliary channel on the transmitter for one second.
2. The parking lights will flash to confirm remote start operation.
3. Once the vehicle has started, it will run for the pre-programmed period
of time or until a shut-down input is triggered.
To perform Valet Take-Over
1. Before turning off the engine, press and release your auxiliary channel
button on the transmitter (or press and release the optional momentary
switch).
2. Turn the ignition key to the OFF position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapses or a shut-
down input is received.
To enter Timer Mode
1. Turn the ignition on.
2. Press and hold the auxiliary channel button controlling remote start.
3. Turn the ignition off while holding the auxiliary channel button.
Using Remote Start with Factory Remote Systems
■
If this remote start system has been interfaced with an original equip-
ment from manufacturer (OEM) factory remote system, the Remote
Start/Valet Take-Over sequence can be programmed to initiate with one
to three (1-3) presses of one of the OEM transmitter buttons.
OEM transmitter button used for Remote Start/Valet Take-Over
sequence______________________________________________
Number of OEM transmitter button presses required to initiate
Remote Start/Valet Take-Over sequence____________________
Cut along dotted line and f
old f
o
r a quick and eas
y r
efer
ence to k
eep in y
our pur
se or w
allet.
✂
✂
10
©
1999 Directed Electronics, Inc.
Summary of Contents for 551 T Series
Page 1: ...551T Series Owner s Guide ...
