5
©
1999 Directed Electronics, Inc.
NOTE:
If programmed for 15-second entry delay, the system will provide
an instant trigger 15 seconds after the door has been opened. (See
Programming Options section of this guide.)
To disarm the system, unlock the doors using your factory keyless
transmitter. You will hear two chirps, and the parking lights will
flash twice. If the siren chirps either four or five times when dis-
arming, refer to the Diagnostics section of this guide. This is called
Tamper Alert.
This feature allows you to override the system without the trans-
mitter should it be lost, damaged or disabled. To do this, you must
have the vehicle's ignition key and know where the Valet
®
switch is
located. Be sure to check with the installer for the location of the
Valet
®
switch.
Turn the ignition to the “run”
position. Press and release the
Valet
®
switch, within 10 sec-
onds. After a few seconds the
LED will stop flashing and the
vehicle should start. If it does
not, you may have waited too
long. Turn the ignition off and
try again.
LOCATION OF VALET
®
SWITCH
______________________________
DRW-35
Disarming the System Without a Transmitter
Disarming
