HANDLING AND TRANSPORTATION
Always transport and keep the unit in an upright position and do not drag over rough floor or
steps. On receipt, unpack the unit carefully and visually inspect for any damage that may
have
been sustained in transit. Record the nature of any damage on the Courier’s Delivery
Note and at the same time inform your supplier.
Warning: If the installation is idle and exposed to freezing temperatures, disconnect
water supply lines and blow out all water from dispensing system.
Ensure the unit can be transported comfortably and in a hygienic manner.
To Remove from Host Machine
Switch off main power to the host machine.
Disconnect water supply to the host machine.
Disconnect electrical connection between the chiller and the host machine.
Disposal of Scrap Units
It is illegal to scrap a refrigeration unit. Before a unit can be scrapped it must first have the
refrigerant removed by a specialist using specialist equipment. Contact your local
refrigeration repair company for advice.
Transportation
This unit must be transported in upright position.
As with all refrigeration systems, irreparable damage can be caused by laying the unit on its
side or even transported upside down. Where a carrier transports the unit, the carton should
always be marked in conspicuous manner, the correct upright position in which it must be
handled. If a unit has been transported incorrectly it should be placed in the correct upright
position and left for 24 hours before attempting to run the system. Failure to observe the
above precautions could seriously damage the system.
Summary of Contents for FORMATIC D12,000
