DTE-3114 – Networked Quad QAM Modulator
USER
MANUAL
9
2.2 LCD display
The LCD display contains the following information:
1.
Device identifier
Programmable from the web and SNMP interface.
2.
Active channels
Number of channels that have been enabled. If no channels
are active, “Idle” is displayed.
3.
Mode
QAM mode and modulation standard.
4.
RF level
Total output power level in dBm.
5.
Frequency
Carrier frequency of each channel in MHz.
6.
Network address
MAC address and IP address (alternating).
When a hardware failure is detected the display will blink continuously and the DTE-3114 has to be
returned to the manufacturer.