Del ozone MPI-300, Installation & Operation Manual

MPI-300 

Installation & Operations Manual

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS.

Read this manual completely before operation of AGW–0500 Ozone Generator Equipment. The High Voltage 
Transformers in this unit create 7,000 volts, with the outer jacket of the High Voltage lead reaching 3,000 volts. 
 

- USE EXTREME CAUTION -

Operate the AGW–0500 on a near level surface with safe access to electrical power. 
Connect to a G.F.C.I. type receptacle.  
Follow all applicable electrical codes. 
Do not bury cord. 
WARNING: To reduce the risk of electrical shock, replace damaged cord immediately. 
ELECTRICAL SHOCK HAZARD: Turn OFF all power switches and disconnect power cord from power source receptacle 
before performing any service work. Failure to do so could result in serious injury or death.

SAFETY CLAIMS

Performance safety testing was based on the 

Hazard Communication Standard as promulgated through the Occupational Safety 

and Health Act of 1970 and documented in the Code of Federal Regulations, Title 29, Chapter XVII, Part 1910, Section 1910.1200.  
The  inherent low hazard due to the AGW-0500’s design and construction, coupled with the safety features, monitoring data, and the 
precautionary directions provided in the owner’s manual are sufficient for The Toxicology Group, LLC, a division of NSF International 
(Ann Arbor, MI), to provide a professional opinion that the AGW-0500 Mobile Ozone Surface Sanitation System poses no safety 
concerns  when operated under the prescribed conditions as set forth in the owner’s manual.

ANTIMICROBIAL CLAIMS

This device has been determined acceptable for use as an ozone generating device providing sanitization and disinfection of hard, 
inanimate, pre-cleaned surfaces, in and around food processing areas (P1). A potable water rinse is not required following the use of 
this device on previously cleaned hard surfaces.  

NSF International Registration for this device is based, partially, upon documentation indicating that it meets all necessary requirements 
including labeling, EPA Establishment Registration, and safety requirements set forth under Federal Insecticide, Fungicide, and 
Rodenticide Act (FIFRA) of June 5, 1947, Section 2(q)(1) and Section 7. 

Efficacy studies conducted according to AOAC Official Method 961.02; Germicidal Spray Products as Disinfectants Test and AOAC 
Official Method 960.09*; Germicidal and Detergent Sanitizing Action of Disinfectants provided the following results:

Organism

Applied Dose

Actual Dose (at nozzle)

Spray Duration

Reduction

Trichophyton mentagrophytes 
(ATCC 9533)

3.0 ppm

1.85-2.25 ppm

30 seconds

 6 log (99.9999%)

Salmonella choleraesuis 
(ATCC 6538)

3.0 ppm

1.85-2.25 ppm

3 minutes

 6 log (99.9999%)

Staphylococcus aureus 
(ATCC 6538)

3.0 ppm

1.85-2.25 ppm

10 minutes

6 log (99.9999%)

Pseudomonas aeruginosa (ATCC 
15442)

3.0 ppm

1.85-2.25 ppm

5 minutes

6 log (99.9999%)

Campylobacter jejuni 
(ATCC 15442)

3.0 ppm

1.85-2.25 ppm

3 minutes

4 log (99.99%)

Listeria monocytogenes 
(ATCC 7644)

3.0 ppm

1.85-2.25 ppm

3 minutes

4 log (99.99%)

Aspergillus flavus 
(ATCC 9296)

3.0 ppm

1.85-2.25 ppm

5 minutes

4 log (99.99%)

Brettanomyces bruxellensis 
(ATCC 10560)

3.0 ppm

1.85-2.25 ppm

3 minutes

4 log (99.99%)

Escherichia coli* 
(ATCC 11229)

3.0 ppm

2.1 ppm

30 seconds

5 log (99.9999%)