Low battery level
The battery level is checked
If the battery level is...
Pre-flight, when connecting
with the autopilot
Less than 90%, an error message appears and you cannot continue the
checklist until you replace the battery with a fully charged battery. Then
you must redo the flight checklist.
Pre-flight, at ARM
l
Less than 35%, an error message appears and you cannot arm the
system and continue the checklist until you replace the battery with
a fully charged battery. (See
Unable to arm the system, page 103
.)
l
Between 35% and 75%, a warning message appears. It is possible to
arm the system but Delair recommends replacing the battery with a
fully charged battery and restarting the checklist.
Pre-flight, after ARM
Less than 15%, the low battery icon on the
Dashboard
turns red
. You
must take the following action:
1. Tap
and then tap
to disarm the rover.
The rover should be in standby mode. If it is not, disarm the rover by
pressing the Mode button three times (three flashes) taking care to
avoid the propellers.
2. Tap
and complete the post-flight checklist.
3. Replace the battery with a fully charged battery and then redo the
flight checklist.
In-flight
Less than 15%, a warning message appears. If the landing location is not
too far from the location of the rover and the battery level is not too low,
tap the
button. Otherwise, tap
.
WARNING –
You must take
immediate action
if you see this
warning. Failure to land the rover in time and the battery runs out, the
motors will shut down. The rover continues to control its flight but will
rapidly lose height and eventually hit the ground at high speed.
104
Delair-Tech
|
676, Rue Max Planck – 31670 Toulouse-Labège, France
|
Tel: +33 (0) 5 82 95 44 06
|
Capital: 238 110,30 € - APE: 3030Z – Intra-Community VAT number: FR90 53 09 69 781 – 530 969 781 R.C.S. Toulouse
This document is the sole property of Delair-Tech and cannot be used or reproduced without the written authorization of Delair-Tech
.
