Disassembling the launcher
1. If you have not yet released the tension on the launcher cord, then do so now.
To release the tension, release the force with the crank very gently while pulling the release handles in
the front of the launcher upward. This is safest done with two people, with one person carefully
winding the crank counter-clockwise to counteract the force on the elastics.
2. Remove the lock pin on the launch dock and detach the launcher cord.
3. Using the crank, tighten the launcher cord so that most of the cord is in the launch slide but the end
remains out. Remove the crank.
4. Slide the launch dock off the front of the launch slide.
5. To detach the V-support, turn the knob upward and then slide the pins out of the holes in the launch
slide. Remove the lock pin on the V-support to fold the legs and then reinsert the lock pin.
CAUTION –
Take care when folding the V-support legs not to jam or cut fingers.
6. Open the handle fixes on the launch slide and fold the launch slide.
7. Return the following items to the launcher bag:
l
safety pin
l
launch dock with lock pin
l
V-support
l
crank
l
launch slide with elastics
For more information, see
Locating your equipment, page 67
.
97
Delair-Tech
|
676, Rue Max Planck – 31670 Toulouse-Labège, France
|
Tel: +33 (0) 5 82 95 44 06
|
Capital: 238 110,30 € - APE: 3030Z – Intra-Community VAT number: FR90 53 09 69 781 – 530 969 781 R.C.S. Toulouse
This document is the sole property of Delair-Tech and cannot be used or reproduced without the written authorization of Delair-Tech
.
