56 • Scanning Procedures
Delcam iQube 2010 Reference Manual
Scanning a Foam Box Impression
This can only be performed with the five camera system(E500).
The following sections give details on scanning a
Foam Box
Impression
:
Scanner Setup (Foam Box Impression) (see page 56)
Orientation & Location (Foam Box Impression) (see page 58)
Scan Settings (Foam Box Impression) (see page 59)
For Best Results:
1.
Switch the scanner on for at least 5 minutes before use.
2.
Ensure the top face of the scanner is smudge free.
3.
Blow any excess dust from the foam box before inverting the foam
box for scanning (reduces dust deposited onto scanner glass).
4.
Initially use two 45mm lifters (21) to lift the heel end of the foam
box. The lifters enable the angled lasers and cameras to see more
of the negative impression.
5.
For deeper foam boxes, increase the height by adding the
extensions (22) to the current lifters at the heel end. At the toe end
of the impression, add two 45mm lifters (21).
