Ÿ
Fold the supplied template and
position template on door edge.
Ÿ
Mark centre of 54mm hole on both
sides of door.
Ÿ
Mark horizontal centre-line of
25mm hole using template, then
mark centre of door thickness.
Ÿ
Drill 54mm hole through door face,
from both sides to avoid
splintering.
Ÿ
Drill 25mm hole into the edge of
the door, central to the door
thickness. Ensure the hole is drilled
squarely.
54mm
Step 1. Door Preparation
DOOR TEMPLATE
60mm BACKSET
Fold on dotted line &
position on door edge
Mark 25mm hole at
centre of door edge.
DB01DOC02- V2 JAN2018
I NSTALLATION INSTRUCTIONS
Deadbolt with Square Furniture
Step 3. Single Cylinder Only
This step only applies to single cylinder product. Skip to
STEP 4 if installing double cylinder product.
For single cylinder product, the
turn-button shaft must be on the
interior side of the door. If required,
re-orientate cylinder as below:
Ÿ
Remove the hex screw at the
rear of the lockbody with allen
key provided.
Ÿ
Flip the cylinder so the shaft is
on the interior side of the door
and slide cylinder back into
lockbody.
Ÿ
Re-install the hex screw into the
lockbody and tighten.
DOOR
THICKNESS
32 - 39mm
39 - 48mm
Step 6. Screw Selection
Ÿ
Measure door thickness and select correct
mounting screws as per table below:
M4 x 40mm LONG
M4 x 50mm LONG
MOUNTING SCREW
Step 5. Lock-Bolt Installation
Ÿ
Rotate key towards edge of
door.
Ÿ
Orientate lock-bolt as shown
and insert into bolt-housing.
Ÿ
Push lock-bolt in until a click
is heard and the lock-bolt
wont go in any further.
Ÿ
Rotate key away from door
edge, if lock-bolt does not
retract then repeat above.
Ÿ
Position faceplate and pilot
drill holes for faceplate
screws, then install two
faceplate screws (#6 x 19mm).
UP
Turn-Button
Shaft
Single
Cylinder
Hex
Screw
Faceplate
screw
Lock-Bolt
Faceplate
Ÿ
Remove both bolt-housing
screws from lockbody.
Ÿ
Remove bolt housing and
lock-bolt from lockbody.
Ÿ
Position bolt-housing and
faceplate centrally within
25mm hole in door edge
and mark around the
rectangular portion of
faceplate.
Ÿ
Chisel marked rectangle to
a depth of 3.5mm or until
bolt-housing with faceplate
is flush with door edge.
Ÿ
Remove bolt-housing and
faceplate from door before
moving to next step.
Step 2. Chisel Faceplate Recess
Lockbody
Bolt-
Housing
Lock-Bolt
Bolt-housing
Screw
Faceplate
Bolt-
Housing
Step 4. Lockbody Installation
Ÿ
Install lockbody into
door, with orientation as
shown.
Ÿ
Install bolt-housing into
25mm hole in door and
locate in lockbody.
Ÿ
Install 2 x bolt-housing
screws, one from each
side.
Bolt-housing
Screw
Lockbody
SUITS 32mm TO 48mm THICK DOORS
