Delfast NAC-CN90, Owner'S Manual

OPERA

TION 

INSTRUCTIONS

OPERA

TION INSTR

UCTIONS

7

delfast.com

Depth of Drive Adjustment 

• 

This tool is equipped with tool-free depth of drive adjustment. Test  

the depth of drive on scrap piece before you start your work.

• 

Turn the knob to adjust the depth of drive 

(Image C)

• 

Repeat above procedure until you find your desired 

  depth-of-drive 

setting.

C.

Operation Instructions

Loading and Unloading the Fuel Cell 

• 

Remove travel casing and insert right angle tip 

(Image A). 

• 

Open the fuel cell door 

(Image B) by pulling the door and rotating.

• 

Insert the fuel cell into the chamber 

(Image c). Align the fuel cell nozzle to the 

fuel stem on the tool.

• 

Close the fuel cell door 

(Image D).

A.

B.

C.

D.

Loading and Unloading Fasteners 

• 

Connect the battery and fuel cell before you load the fasteners. The tool has the chance to cycle    

once when connected to the battery. If you load the fastener before the battery is connected, the   

fastener may be fired accidentally.

• 

Point the nozzle away from any personnel and keep your finger away from the trigger when  

loading the fastener.

• 

To load the nails slide them in the rear end of the magazine past release button B 

(Image B). 

• 

Pull the pusher until it picks up the nails, and pushes the nails into the firing chamber.

• 

To unload the nails from the magazine, orient magazine vertical, press release button A 

(Image A).

• 

Nails will fall to release button B. Press release button B and nails will exit the magazine.

A.

Release Button A

Release Button B

B.