Installation
Section 2
18
Part Number: 9294839 03/17
T-4 Rack Slide Installation
Edge Support for 18” x 26” pans
Installed T-4 Tray Slide for 18”x 26” pan
System Name
T-4
Slide Style
Rack
Support Style
Edge
Compatible with 12” x 20” Pans
No
Compatible with 18” x 26” Pans
Yes
The T-4 rack slide system is designed to support 18” x 26”
pans by the edge of the pan. The T-4 rack slide system
consists mounting plates for each side, and a set of racks.
The racks are formed of heavy gauge metal wire.
Each set of rack slides is mounted at the same height across
a door section. If the rack slides are not at the same height,
the pan cannot be held securely. Each rack uses two (2)
mounting plates.
T-4 Installation Instructions
1. Start assembling the mounting plates at the bottom
of the door section. Place a bottom mounting plate so
that each set of tabs engages a cutout on the pilaster.
Push the mounting plate down to secure the plate to
the cutouts.
NOTE: A dead-blow hammer is recommended to seat the
tab into the cutouts.
2. On the same side place a top mounting plate with the
bottom edge 20” (51cm) above the top of the lower
mounting plate.
3. Repeat steps 1-2 on the opposite side. Verify that all
mounting plates are lined up across the door section.
4. For a full section installation, repeat steps 1-3 for the
upper half.
5. Place each rack on two (2) mounting plates.
Pilast
er
Rack
Moun
ting Pla
te
6. Verify that all tray slides are lined up evenly.
NOTE: An easy check to verify correct installation is to slide a
pan of the appropriate size into each slide. If the pan is held
securely, and is level inside the door section, the installation
has been successful.
