Figure 34 Removing the M.2 module
Install M.2 module on the BOSS Card
Procedure
1. Align the M.2 module connectors with the connectors on the BOSS card.
2. Tilt the M.2 module downwards until the module is seated firmly on the card.
3. Tighten the screw that secures the M.2 module on the BOSS card.
Figure 35 Installing the M.2 module
Install BOSS card onto expansion card riser 1
Procedure
1. Pull the expansion card latch out of the slot.
2. Hold the BOSS card by its edges, and align the card edge connector with the expansion card
connector on the riser.
Remove and replace assemblies
50
Dell EMC Integrated Data Protection Appliance DP4400 Service Procedures