Replacing the base cover
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
Topics:
•
•
Procedure
1. Slide the tabs on the base cover into the slots on the computer base and snap the base cover into place.
2. Replace the screws that secure the base cover to the computer base.
Post-requisites
.
10
20
Replacing the base cover
Summary of Contents for Inspiron 14 5000
