Replacing the memory modules
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
Topics:
•
•
Procedure
1. Align the notch on the memory module with the tab on the memory-module slot.
2. Slide the memory module firmly into the slot at an angle and gently press the memory module down until it clicks into place.
NOTE:
If you do not hear the click, remove the memory module and reinstall it.
1. notch
2. memory module
3. securing clips
4. memory-module slot
5. tab
Post-requisites
1. Replace the
.
2. Replace the
.
16
Replacing the memory modules
27
Summary of Contents for Inspiron 14 5000
