Replacing the display assembly
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
Topics:
•
•
Procedure
1. Place the palm rest at the edge of the table with the speakers facing away from the edge.
2. Align the screw holes on the palm-rest assembly with the screw holes on the display hinges.
3. Replace the screws that secure the display hinges to the palm-rest assembly.
4. Route the antenna cables through its routing guides on the palm-rest assembly.
5. Route the display cable through its routing guides on the palm-rest assembly.
Post-requisites
1. Replace the
2. Replace the
3. Replace the
4. Replace the
5. Replace the
.
6. Replace the
7. Follow the procedure from step 5 to step 7 in “
”.
8. Replace the
9. Replace the
10. Replace the
.
11. Replace the
.
36
56
Replacing the display assembly
Summary of Contents for Inspiron 14 5000
