Initializing the TPM 2.0 for TXT users
1
While booting your system, press F2 to enter System Setup.
2
On the
System Setup Main Menu
screen, click
System BIOS
>
System Security Settings
.
3
From the
TPM Security
option, select
On
.
4
Save the settings.
5
Restart your system.
6
Enter
System Setup
again.
7
On the
System Setup Main Menu
screen, click
System BIOS
>
System Security Settings
.
8
Select the
TPM Advanced Settings
option.
9
From the
TPM2 Algorithm Selection
option, select
SHA256
, then go back to
System Security Settings
screen.
10 On the
System Security Settings
screen, from the
Intel TXT
option, select
On
.
11 Save the settings.
12 Restart your system.
rSPI card
NOTE:
The inlet temperature sensor is located on the rSPI card.
Removing the rSPI card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
.
Steps
1
Using the Torx #8 screwdriver, remove the screw securing the rSPI card to the system board.
2
Holding the rSPI card by its edges, lift the card away from the system.
CAUTION:
To prevent damage to the rSPI card, you must not tilt the card while lifting it from the system board.
Installing and removing system components
101
