Figure 81. Installing the system battery
Next steps
1
Follow the procedure listed in
After working inside your sled
2
Enter the System Setup to confirm that the battery is operating properly.
3
Enter the correct time and date in the System Setup's
Time
and
Date
fields.
4
Exit the System Setup.
5
To test the newly installed battery, remove the system from the enclosure, for at least an hour.
6
Reinstall the system into the enclosure, after an hour.
7
Enter the System Setup and if the time and date are still incorrect, see
.
Replacing the system battery - Option B
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. See the
safety instructions that came with your system for more information.
1
Follow the safety guidelines listed in
.
2
Follow the procedure listed in
Before working inside the sled
Steps
1
Locate the system battery on the system.
2
To remove the battery:
a Push the battery holder clip.
NOTE:
Ensure that you do not push the battery holder clip more than 3.2 millimeters, It may damage the
battery holder.
b Push the battery toward the positive side of the battery until the battery disengages from the connector.
c Lift the battery away from the system.
108
Installing and removing system components
