3
Steps
1
Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
System board jumpers and connectors
section.
2
If installed, remove the USB memory key from the USB port.
3
Place the replacement USB memory key into the USB port.
Next steps
1
.
2
While booting, press F2 to enter
System Setup
and verify that the system detects the USB memory key.
3
Follow the procedure listed in the
After working inside your sled
section.
System battery
The system battery is used to power the real-time clock and storing the BIOS settings of the sled.
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
1
Follow the safety guidelines listed in the
section.
2
Follow the procedure listed in the
Before working inside your sled
section.
3
Steps
1
Locate the battery socket. For more information, see the
System board jumpers and connectors
section.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
2
Use a plastic scribe to pry out the system battery.
Figure 86. Removing the system battery
3
To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4
Press the battery into the connector until it snaps into place.
116
Installing and removing sled components
