Figure 55. Removing the processor and heat sink module
Next step
1
Install the processor and heat sink module
.
Removing the processor from the processor and heat sink
module
Prerequisites
NOTE:
Only remove the processor from the processor and heat sink module (PHM) if you are replacing the processor or heat
sink. This procedure is not required when replacing a system board.
1
Follow the safety guidelines listed in the
section.
2
Follow the procedure listed in the
Before working inside your sled
section.
3
Remove the processor and heat sink module
Steps
1
Place the heat sink with the processor side facing up.
2
Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
paste seal.
3
Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Installing and removing sled components
89