NOTE:
Support the sled with both hands while sliding it out of the enclosure.
3
Install the I/O connector cover on the sled.
CAUTION:
To protect the I/O connector pins, install the I/O connector cover every time a sled is removed from the
enclosure.
Figure 14. Installing the I/O connector cover on the sled
CAUTION:
If you are permanently removing the sled, install a blank. Operating the enclosure for extended periods of
time without a blank installed can cause the enclosure to overheat.
NOTE:
The color of the I/O connector cover may
differ.
Next step
1
Install the sled or blank into the enclosure
Installing the sled into the enclosure
Prerequisite
1
Follow the safety guidelines listed in the
section.
Steps
1
Remove the I/O connector cover from the I/O connector(s) and store for future use.
CAUTION:
To prevent damage to the I/O connectors, do not touch the connectors or the connector pins.
44
Installing and removing sled components