Figure 23. Removing the PEM
Next step
1
Installing the processor expansion module
.
Installing the processor expansion module
Prerequisites
1
Follow the safety guidelines listed in the
section.
2
Follow the procedure listed in the
Before working inside your sled
section.
Steps
1
Lift the processor expansion module (PEM) by holding the blue handle and release lever.
CAUTION:
To avoid damage to the components on the edges of the PEM board, carefully lift and place the PEM by
holding only the blue handle and release lever.
2
Align the guides on the PEM with the guide slots on the sled and place the PEM on the sled.
3
Lower the release lever until it hooks into place with the blue handle.
Installing and removing sled components
53
