Steps
1
Locate the IDSDM or vFlash connector on the system board.
To locate IDSDM or vFlash, see the
System board jumpers and connectors
section.
2
Align the IDSDM or vFlash module with the connector on the system board.
3
Push the IDSDM or vFlash module until it is firmly seated in the connector on the system board.
Figure 58. Installing the IDSDM or vFlash module
Next steps
1
Install the MicroSD cards. For more information, see
.
NOTE:
Reinstall the MicroSD cards into the slots based on the labels you had marked on the cards during removal.
2
Follow the procedure listed in
After working inside your system
.
LOM riser card
The LOM riser card is a small, removable mezzanine card, which provides the flexibility of selecting different network connectivity options.
Removing the LOM riser card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Remove the air shroud. For more information, see
.
4
If installed, remove the risers. For more information see,
Removing the expansion card risers
.
98
Installing and removing system components
