Figure 21. Removing the bracket
3. Remove the screw and separate the M.2 riser board from the bracket.
Next steps
.
Installing the cable M.2 riser board
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in the
Before working inside your system
Steps
1. Place the bracket on the M.2 riser board and secure it by tightening the screw.
2. Connect the SlimSAS cable to the M.2 riser board.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
3. Insert and push the M.2 riser board into the system board.
4. Using the Phillips #1 screwdriver, secure the M.2 riser board into the system board with the screw.
Installing and removing system components
55
