4.
5.
.
6.
7. Disconnect the cables from the mini PERC module.
8. Disconnect the cables from the cable M.2 riser board.
9.
Remove the motherboard bridge module.
Steps
1. Using the Phillips #2 screwdriver, remove the four screws that secure the sled cable kit to the MB bridge module.
2. Lift the sled cables kit from the sled.
Figure 30. Removing the sled cables kit
NOTE:
Follow the same steps to remove the other sled cables kit.
Next steps
Installing the sled cables kit
Prerequisites
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in the
Before working inside your system
Installing and removing system components
63
