The Progress field shows the percentage of completion.
CAUTION
Do not force the disk to go Online. This can potentially corrupt the disk array
and result in data loss. Contact Dell EMC Support for assistance.
3. In the PowerProtect Data Manager UI, on the Appliance page, verify that the capacity cube
node status is online.
l
If the capacity cube node status is not online, go to the Alerts and Events page, select the
checkbox next to the alert related to the drive replacement procedure, and click
Acknowledge.
l
On the Appliance page, verify that the capacity cube node status is online.
X400H mid hard drive replacement
This section describes how to replace the three HDDs in the mid drive tray in physical slots 14, 15,
and 16 in an X400H capacity cube.
Removing the drive carrier from the mid drive tray
Before you begin
1. Follow the
.
2. Identify the faulted drive by checking the
in the Alerts and Events
>
Appliance tab in
the PowerProtect Data Manager UI. Note down the node ID (for example, Capacity cube 06)
and the drive number.
3. Put the X400 capacity cube into maintenance mode in the PowerProtect Data Manager UI.
a. In the PowerProtect Data Manager UI, click the Appliance tab in the left navigation pane.
b. On the Appliance page, in the Capacity Cubes section, click the Details icon next to the
capacity cube you want to put into maintenance mode.
The Cube Details page appears.
c. On the Cube Details page, click Put Into Maintenance Mode.
A
Capacity Cube-In Maintenance Mode
job is created. You can monitor this job on
the Jobs page. The job takes approximately five minutes to complete.
4.
Extend the X400 capacity cube from the rack
.
5.
Remove the X400 capacity cube cover
.
If the drive is online, the green activity/fault indicator flashes as the drive is turned off. When the
drive indicators are off, the drive is ready for removal.
Procedure
1. Lift the drive carrier handle upward.
2. Press the release tab on the drive tray and lift the drive carrier handle upward to disengage
the drive from the backplane.
3. Hold the drive carrier handle and lift the drive carrier out of the drive tray.
X400 capacity cube CRU procedures
PowerProtect X400 Appliance Customer Replaceable Unit (CRU) Procedures
33
