background image

Dell™ 1900FP Flat Panel Color Monitor Quick Setup Guide

1

Dell™ 1900FP Flat Panel Color Monitor

Quick Setup Guide

Safety Instructions

Observe the following safety guidelines when connecting and using your monitor:

Be sure that your monitor is electrically rated to operate with the AC power available in your location.

Locate your monitor near an easily accessible electrical outlet.

Place the monitor on a solid surface and treat it carefully. The screen can be damaged if dropped, sharply hit, or

touched with a sharp or abrasive implement.

Put your monitor in a location with low humidity and a minimum of dust.

Never use your monitor if the power cable has been damaged. Do not allow anything to rest on the power cable,

and keep the cable away from where people could trip over it.

Never insert anything metallic into the monitor openings. Doing so may create the danger of electric shock.

To avoid electric shock, never touch the inside of the monitor. Only a qualified technician should open the monitor's

case.

Be sure to hold the plug, not the cable, when disconnecting the monitor from an electrical outlet.

Openings in the monitor cabinet are provided for ventilation. To prevent overheating, these openings should not be

blocked or covered. Also, avoid using the monitor on a bed, sofa, rug, or other soft surface. Doing so may block the

ventilation openings in the bottom of the cabinet. If you put the monitor in a bookcase or some other enclosed space,

be sure to provide adequate ventilation.

Do not expose the monitor to rain or use it near water. If the monitor accidentally gets wet, unplug it and contact an

authorized dealer immediately. You can clean the exterior of the monitor with a damp cloth when necessary, but be

sure to unplug the monitor first.

If your monitor does not operate normally-in particular, if there are any unusual sounds or smells coming from it

unplug the monitor immediately and contact an authorized dealer or service center.

Connecting Your Monitor to a Computer

1. Turn off your computer and unplug its power cable.
2. Connect either the white (digital DVI-D) or the blue (analog D-SUB) display connector cable to the corresponding

video port on the back of your computer. 

Do not use both cables on the same PC. 

The only case in which both

cables can be used is if they are connected to two different PCs with appropriate video systems. (The graphics are

for illustration only. System appearance may vary). 

3. Connect the power cable for your display to the power port on the back of the display. 
4. Plug the power cables of your computer and your display into a nearby outlet. 
5. Turn on your display and computer.

If your monitor displays an image, installation is complete. If it does not display an image, see Troubleshooting.

Note: If your PC does not support the connection for the "digital" video cable then it can remain unconnected

or it can be removed from the back of the monitor. This will not affect the performance of the monitor.

Summary of Contents for 1900FP - UltraSharp - 19" LCD Monitor

Page 1: ... cabinet If you put the monitor in a bookcase or some other enclosed space be sure to provide adequate ventilation Do not expose the monitor to rain or use it near water If the monitor accidentally gets wet unplug it and contact an authorized dealer immediately You can clean the exterior of the monitor with a damp cloth when necessary but be sure to unplug the monitor first If your monitor does no...

Page 2: ... ROM drive then click Have Disk 6 Type d change the drive letter to match your CD ROM drive if it is not drive D in the Copy manufacturer s files from box then click OK 7 Click Next Next and then Finish to complete the installation A 1 2 B C D E F G A B VIDEO Input Indicators and Select button Use this button to select between two different video signals that may be connected to your monitor Video...

Page 3: ...2000 Windows 98 or Windows NT set the display resolution to 1280 x 1024 as follows 1 Click StartÆ Æ Æ ÆSettingsÆ Æ Æ ÆControl Panel 2 Double click the Display icon in the Control Panel window and the click the Settings tab 3 In the Desktop area move the slidebar to 1280 by 1024 pixels Then click OK Accessing the User s Guide Online or via CD To view the latest monitor User s Guide access the SUPPO...

Page 4: ...nformation in this document is subject to change without notice 2001 Dell Computer Corporation All rights reserved Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly forbidden Trademarks used in this text Dell and the DELL logo are trademarks of Dell Computer Corporation Microsoft and Windows are registered trademarks of Microsoft Corporat...

Reviews: