Steps
1. Align and place the power button with fingerprint reader assembly on the system and adhere it to the palmrest.
2. Align and place the power button with fingerprint reader bracket in place, and install the three (M1.5x2.5) screws.
3. Fold back the display hinge and install the three (M2.5x5) screws to secure it.
Next steps
1. Install the
2. Install the
.
3. Install the
.
4. Install the
5. Install the
After working on your computer
.
Battery
Removing the 4-cell battery
Prerequisites
before working inside your computer
.
2. Remove the
.
3. Remove the
4. Remove the
.
NOTE:
If battery was disconnected from system board for service, there will be a delay during system boot-up as the
system will undergo RTC battery reset.
About this task
The following images indicate the location of the battery and provide a visual representation of the removal procedure.
Removing and installing components
37