OSD Warning Messages
Back
Mode
When PIP/PBP activated
PIP/PBP Source
PIP Position
PIP Size
PIP/PBP Contrast
PIP/PBP Hue/Tint
PIP/PBP Saturation
Exit Menu
or
PIP/PBP submenu when PIP/PBP ON
(main source is VGA/DVI
-
D input)
PIP/PBP submenu when PIP/PBP ON
or
NOTE:
When using DVI source, the contrast adjustment is not available.
Push
to go back to the main menu.
There is two modes: PIP (Picture in Picture) and PBP (Picture By Picture)
Use
and
to browse and
to select "Off", "PIP" or "PBP".
When PIP/PBP
is activated, select "Swap" to exchange the input source for the main screen and PIP/PBP window.
Select an input signal for PIP
/PBP
. (VGA/DVI/S-Video/Composite/Component)
Use
and
to browse and
to select.
Select PIP window position.
Use
and
to browse and
to select.
Select PIP window size.
Use
and
to browse and
to select.
Adjust the contrast level of the picture in PIP
/PBP
Mode.
reduce the contrast
increases the contrast
This function shifts the color of PIP
/PBP
image to green or purple. This is used to adjust for desired flesh tone color.
shifts image color towards green
shifts image color towards purple
Adjust the color saturation of PIP
/PBP
image.
makes the image look more monochrome
makes the image look more colorful
Push
to exit the OSD main menu.
Your monitor will prompt you to achieve the best performance when you select PBP. You may see the following messages under certain combinations of input
sources in PBP mode.
