Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
2. Slide the solid-state drive into the solid-state drive slot.
3. Place the thermal shield on the solid-state drive.
4. Align the screw holes on the thermal shield with the screw holes on the solid-state drive and system board.
5. Replace the two screws (M2x4) that secure the solid-state drive to the system board.
Next steps
1. Install the
.
2. Follow the procedure in
After working inside your computer
.
Procedure to move the screw mount in SSD slot one
About this task
This computer supports two solid-state drive form factors in SSD slot one:
●
M.2 2230
●
M.2 2280
If you are replacing the current solid-state drive in SSD slot one, with another solid-state drive that is of a different form factor, see
the following procedure to move the location of the screw mount in SSD slot one.
Steps
1. Slide to remove the screw mount from the palm-rest and keyboard assembly.
2. Slide the screw mount into the other screw mount slot on the palm-rest and keyboard assembly.
32
