10
SCG2013 | Brocade VDX 6740 Switch Configuration Guide for Dell SC Series SANs
4
Configuring VCS ID and Rbridge-ID (optional)
Refer to Brocade documentation for details on VCS and Ethernet fabric. The following commands show
the steps to configure the rbridge-id and VCS id to 2 on a switch. The VDX 6740 is in Fabric Cluster mode
by default and configuration change is not required for the mode.
sw0#
show vcs
Config Mode : Local-Only
VCS Mode : Fabric Cluster
VCS ID : 1
Total Number of Nodes : 1
Rbridge-Id WWN Management IP VCS Status
Fabric Status HostName
--------------------------------------------------------------------------------
------------------------------
2 >10:00:50:EB:1A:2D:F2:64* 77.77.77.77 Online
Online sw0
sw0#
vcs vcsid 2
This operation will change the configuration to default and reboot the switch.
Do you want to continue? [y/n]:
y
Note:
The switch will reboot.
sw0#
vcs rbridge-id 2
This operation will change the configuration to default and reboot the switch.
Do you want to continue? [y/n]:
y
Note:
The switch will reboot.
