Steps
1. Align the notch on the solid-state drive with the tab on the solid-state drive connector.
2. Insert the solid-state drive at a 45-degree angle into the slot on the system board.
NOTE:
When replacing a M.2 2280 solid-state drive from a M.2 2230 solid-state drive, ensure to move the standoff nut
to the M.2 2230 solid-state drive slot position.
3. Replace the single (M2x3.5) screw to secure the solid-state drive to the system board.
4. Align and place the M.2 heat-sink over the solid-state drive.
5. Tighten the four captive screws to secure the M.2 heat-sink to the system board.
Next steps
1. Install the
.
2. Install the
.
After working inside your computer
.
Removing the M.2 2280 PCIe solid-state drive
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
About this task
The following images indicate the location of the M.2 2280 solid-state drive and provide a visual representation of the removal
procedure.
56
Removing and installing components
Summary of Contents for D03T
