Figure 135. Installing the intrusion switch module
Next steps
1.
Install the expansion card riser
.
2. Follow the procedure listed in
After working inside your system
.
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in the
Before working inside your system
3.
Remove the expansion card riser
.
Steps
1. Open the blue latch to disengage the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
Installing and removing system components
155