Figure 67. Installing the rear drive cage
Next steps
, if needed.
2. Connect all the cables to the rear drive cage.
3.
4. Follow the procedure listed in
After working inside your system
.
Front PERC module
Removing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in the
Before working inside your system
3.
4. If installed,
5. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
2. Slide and pull the front PERC module to disengage from the connector on the drive backplane.
68
Installing and removing system components