Replacing the Dell logo board
WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in
Before working inside your Embedded Box PC
. After working inside your
Embedded Box PC, follow the steps in
After working inside your Embedded
. For more safety best practices, see the Regulatory Compliance
home page at
www.dell.com/regulatory_compliance
Procedure
1
Place the Dell logo board into the front chassis.
2
Replace the screws that secure the Dell logo board to the chassis.
3
Align the screw holes on the left chassis with the screw holes on the front
chassis.
4
Replace the screws that secure the left chassis to the front chassis.
Post-requisites
1
Replace the
2
Follow step 2 to step 6 in
3
Replace the
4
Replace the
5
Replace the
6
Replace the
.
7
Replace the
8
Replace the
.
9
Replace the
.
10
Replace the
or
11
Replace the
12
Replace the
.
13
Replace the
.
14
Replace the
(if necessary).
132
Summary of Contents for Embedded Box PC5000
Page 122: ...3 Lift the system board off the chassis 1 chassis 2 system board 122 ...
Page 131: ...3 Remove the Dell logo board from the front chassis 1 Dell logo board 2 front chassis 131 ...
Page 133: ...15 Follow step 2 to step 8 in Replacing the back cover 133 ...
Page 136: ...CANbus The CANBus daughter card is an optional accessory for Embedded Box PC 136 ...
