Installing MDS Series directors
69
Installing Directors into the EC-1700 Cabinet
Note:
Before proceeding with the installation of the lower MDS director,
verify that the cable tray is located directly beneath the upper right hand
shelf-bracket as seen in
Figure 47, “Lower cable tray,”
. If the cable tray is not
directly beneath the upper shelf-brackets position, move it to this location.
This will facilitate installation of the lower MDS director.
Figure 47
Lower cable tray
After following the Cisco procedures for unpacking, handling and
mounting the MDS director onto these lower shelf brackets, secure
the MDS director to the front vertical NEMA rails by using the screws
provided with the Cisco accessory kit that came with the MDS
director. Attach these screws to the clip nuts that are pre-mounted on
the front vertical NEMA rails. See
(EC-1700
cabinet showing U hole location) and
(EC-1700
cabinet isometric view) for the clip nut locations if you need to
readjust any of the clip nuts.
