Figure 61. Installing the system battery
Next steps
1
If removed, install the expansion card riser.
2
Install the sled into the enclosure.
3
Follow the procedure listed in
After working inside your system
.
4
While booting, press F2 to enter System Setup and ensure that the battery is operating properly.
5
Enter the correct time and date in the System Setup
Time
and
Date
fields.
6
Exit System Setup.
Related link
Installing the expansion card riser assembly
Installing a sled
System board
A system board (also known as the motherboard) is the main printed circuit board in the system with different connectors used to connect
different components or peripherals of the system. A system board provides the electrical connections to the components in the system to
communicate.
Removing the system board
Prerequisites
CAUTION:
Do not attempt to remove the TPM plug-in module from the system board. Once the TPM plug-in module is installed,
it is cryptographically bound to that specific system board. Any attempt to remove an installed TPM plug-in module breaks the
cryptographic binding, and it cannot be reinstalled or installed on another system board.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Remove the sled from the chassis.
4
Remove the air shroud.
5
Remove the expansion card risers.
6
Remove the processor heat sink module.
7
Remove the memory modules.
8
If installed, remove OCP card.
9
If installed, remove the mezzanine card.
10
Linking board
Installing and removing system components
117
Summary of Contents for EMC PowerEdge C6420
Page 1: ...Dell EMC PowerEdge C6420 Regulatory Model E43S Series Regulatory Type E43S001 ...
Page 8: ...Figure 1 Supported configurations for PowerEdge C6420 8 PowerEdge C6420 overview ...
Page 64: ...Figure 12 Removing a sled 64 Installing and removing system components ...
Page 66: ...Figure 14 Installing a sled 66 Installing and removing system components ...
