Figure 19. Installing the air shroud
Next steps
1
If disconnected, reconnect the battery cable to the PERC card.
2
Install the sled into the enclosure.
3
Follow the procedure listed in
After working inside your system
.
Related link
System memory
The system supports DDR4 registered DIMMs (RDIMMs) and load reduced DIMMs (LRDIMMs). System memory holds the instructions
that are executed by the processor.
NOTE:
MT/s indicates DIMM speed in MegaTransfers per second.
Memory bus operating frequency can be 2666 MT/s, 2400 MT/s, or 2133 MT/s depending on the following factors:
•
DIMM type (RDIMM or LRDIMM)
•
Number of DIMMs populated per channel
•
System profile selected (for example, Performance Optimized, or Custom [can be run at high speed or lower])
•
Maximum supported DIMM frequency of the processors
Your system contains 16 memory sockets split into two sets of 8 sockets, one set per processor. Each 8-socket set is organized into
channels. In each channel, the release tabs of the first socket are marked white, the second socket black.
Installing and removing system components
71
Summary of Contents for EMC PowerEdge C6420
Page 1: ...Dell EMC PowerEdge C6420 Regulatory Model E43S Series Regulatory Type E43S001 ...
Page 8: ...Figure 1 Supported configurations for PowerEdge C6420 8 PowerEdge C6420 overview ...
Page 64: ...Figure 12 Removing a sled 64 Installing and removing system components ...
Page 66: ...Figure 14 Installing a sled 66 Installing and removing system components ...
