Figure 72. Installing the system battery
Next steps
install the expansion card riser
2. Follow the procedure listed in
After working inside your system
.
3. While booting, press F2 to enter System Setup and ensure that the battery is operating properly.
4. Enter the correct time and date in the System Setup
Time
and
Date
fields.
5. Exit System Setup.
System board
Removing the system board
Prerequisites
CAUTION:
Do not attempt to remove the TPM plug-in module from the system board. Once the TPM plug-in
module is installed, it is cryptographically bound to that specific system board. Any attempt to remove an
installed TPM plug-in module breaks the cryptographic binding, and it cannot be reinstalled or installed on
another system board.
CAUTION:
To avoid damage to the system board, ensure that the system board does not touch the side walls of
the sled chassis, while sliding the system board into the sled.
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in
Before working inside your system
3.
from the chassis.
4.
.
5.
Remove the expansion card risers
6.
Remove the processor heat sink module
7.
.
8. If installed,
9. If installed,
10.
11. Disconnect all the cables from the system board.
12. Keep the Phillips #1 screwdriver and #4 nut driver ready.
Steps
1. Remove the screws that secure the system board to the sled assembly.
CAUTION:
Do not lift the system board by holding a memory module slot, any other connector, or
component.
2. Hold the system board by the edges, and lift the system board away from the sled.
78
Installing and removing enclosure components