11
Disconnect all the cables from the system board.
12
Keep the Phillips #1 screwdriver and #4 nut-driver ready.
Steps
1
Remove the screws that secure the system board to the sled assembly.
CAUTION:
Do not lift the system board by holding a memory module slot, any other connector, or component.
2
Hold the system board by the edges, and lift the system board away from the sled.
Figure 62. Removing the system board
Next step
Install the system board.
Related link
Removing a sled
Removing the air shroud
Removing the expansion card riser assembly
Removing a processor and heat sink module
Removing a memory module
Removing the OCP card
Removing a mezzanine card
Removing the support bracket
Installing system board
Installing system board
Prerequisite
Follow the safety guidelines listed in
Steps
1
Holding the system board by the edges, slide the system board into the sled.
2
Install the screws that secure the system board to the sled.
118
Installing and removing system components
Summary of Contents for EMC PowerEdge C6420
Page 1: ...Dell EMC PowerEdge C6420 Regulatory Model E43S Series Regulatory Type E43S001 ...
Page 8: ...Figure 1 Supported configurations for PowerEdge C6420 8 PowerEdge C6420 overview ...
Page 64: ...Figure 12 Removing a sled 64 Installing and removing system components ...
Page 66: ...Figure 14 Installing a sled 66 Installing and removing system components ...