Related link
Installing a memory module
Prerequisite
Follow the safety guidelines listed in
Steps
1
Locate the appropriate memory module socket.
CAUTION:
Handle each memory module only by the edges, ensuring not to touch the middle of the memory module or
metallic contacts.
CAUTION:
To prevent damage to the memory module or the memory module socket during installation, do not bend or
flex the memory module. You must insert both ends of the memory module simultaneously.
2
Open the ejectors on the memory module socket outward to allow the memory module to be inserted into the socket.
3
Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the memory module
in the socket.
CAUTION:
Do not apply pressure at the center of the memory module; apply pressure at both ends of the memory
module evenly.
NOTE:
The memory module socket has an alignment key that enables you to install the memory module in the socket in
only one orientation.
4
Press the memory module with your thumbs until the socket levers firmly click into place.
Figure 22. Installing a memory module
Next steps
1
Install the air shroud.
2
Follow the procedure listed in
After working inside your system
.
3
To verify if the memory module has been installed properly, press F2 and navigate to
System Setup Main Menu > System BIOS >
Memory Settings
. In the
Memory Settings
screen, the System Memory Size must reflect the updated capacity of the installed
memory.
4
If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is firmly
seated in the memory module socket.
74
Installing and removing system components
Summary of Contents for EMC PowerEdge C6420
Page 1: ...Dell EMC PowerEdge C6420 Regulatory Model E43S Series Regulatory Type E43S001 ...
Page 8: ...Figure 1 Supported configurations for PowerEdge C6420 8 PowerEdge C6420 overview ...
Page 64: ...Figure 12 Removing a sled 64 Installing and removing system components ...
Page 66: ...Figure 14 Installing a sled 66 Installing and removing system components ...
