Next steps
1
Install the processor and heat sink module.
2
Install the sled into the enclosure.
3
Follow the procedure listed in
After working inside your system
.
Related link
Installing a processor and heat sink module
Installing a sled
Removing the non-fabric processor from the processor and
heat sink module
Prerequisites
NOTE:
Only remove the processor from the processor and heat sink module if you are replacing the processor or heat sink. This
procedure is not required when replacing a system board.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Remove the sled from the enclosure.
4
Remove the air shroud.
5
Remove the processor and heat sink module.
Steps
1
Place the heat sink with the processor side facing up.
2
Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
paste seal.
3
Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Figure 34. Loosening the processor bracket
4
Lift the bracket and the processor away from the heat sink, and place the processor connector side down on the processor tray.
5
Flex the outer edges of the bracket to release the bracket from the processor.
Installing and removing system components
87
Summary of Contents for EMC PowerEdge C6420
Page 1: ...Dell EMC PowerEdge C6420 Regulatory Model E43S Series Regulatory Type E43S001 ...
Page 8: ...Figure 1 Supported configurations for PowerEdge C6420 8 PowerEdge C6420 overview ...
Page 64: ...Figure 12 Removing a sled 64 Installing and removing system components ...
Page 66: ...Figure 14 Installing a sled 66 Installing and removing system components ...
